|
|
Introduction
| HD Strip Heaters | Mighty-Tuff Strip Heaters | Mica Strip Heaters | Channel Heaters
| Mini-Tubular Heaters
MICA STRIP HEATERS
Versatile,
efficient and economical, the Mica Strip Heater is of the same
construction as the Mica Band Heater in flat design. Because
of the range of dimensions and configuration possible, these
units furnish even heat distribution for use in hot plates, sealing
equipment, hot stamping, dies and molds and hundreds of other
surface heating applications.
(PDF file
- 4k)
 |
|
 |
| TYPE
L1 - Widths over 3/4". 12"
lead wires standard. |
|
TYPE
L2 - Widths over 1". 12"
lead wires standard. |
 |
|
 |
| TYPE
T1 - Widths over 1". Requires
1" cold section each end. |
|
TYPE
T2 - Widths over 1-1/2". Requires
1-1/2" cold section at terminal end. |
 |
|
 |
| TYPE
T3 - Widths 1-3/4" cold section
at terminal end. |
|
TYPE
B2 - (Tapped Terminals) |
T1,
T2 & T3 terminals have 10-24 thread and require 15/16"
clearance from surface being heated. B1, B2 & B3 require
1/2" clearance.
|
 |
|
 |
| Full
case - For use where surface contact
on both sides of heater is necessary. |
|
Mica Strip Heaters
are also available with lead modifications fig. 3,5,6 & 16(shown)
and plug configurations as shown in the Mica Band Heater section. |
Watt densities to 35wi2. Standard thickness is 5/32". When ordering,
specify: length and width, type of termination, wattage and voltage
(resistance tolerance +10; -5%) and special features.
|