Introduction | Flexible Heaters | Mighty-Tuff Band Heaters | Aluma-Flex Band Heaters | Mighty-Miser Ceramic Band Heaters
MOUNTING CONFIGURATIONS

Fig. 9 Strap-made from a low expansion alloy to tighten around the whole circumference of the heater with 5/16 socket head bolt.
Low Profile: H = 1/4", 1/2" wide (Supplied on 3" I.D. and less). Standard Profile: H = 3/8", 5/8" wide (supplied on 3-1/8" I.D. and larger). Also available with hose clamp or punch lock strap.

Fig. 10 By-Pass Strap-Supplied on less than 2" wide with terminals or Figures 5, 6 or 16.


Fig. 8 Mounting Flange-a secondary means for mounting where a built-in method is preferred with with 5/16 socket head bolt.

Fig. 11 Wedge Mount-for applications where an extremely low profile is required or where access is limited. Available with Figures 1, 3, 4, 5, 7 and 16 leads.

Fig. 18: Low Profile Barrel Nut Assembly Welded to Sheath with 6-32 screw.

Fig. 19: Standard Profile Barrel Nut Assembly Welded to Sheath with 10-32 screw.

Fig. 20: 1-1/4" Wide Barrel Assembly Welded to Sheath with 5/16 - 18 socket head screw.

Fig. 21 Quick Release Assembly with Spring Loaded Screw ­ Assembly Welded to Sheath with 1/4 - 20 screw.

home | about ogden | products { flexible heaters & band heaters | insertion heaters | process electric heaters | strip heaters & mini-tubular heaters | controls, sensors & accesories } | | contact ogden

OGDEN MANUFACTURING CO.
103 Gamma Drive, Pittsburgh, PA 15238
phone 800-OMC-4921 or 412-967-3906
fax 888-OMC-9890 or 412-967-3930