Introduction | Flexible Heaters | Mighty-Tuff Band Heaters | Aluma-Flex Band Heaters | Mighty-Miser Ceramic Band Heaters
Screw Terminals: Special Features:

Fig. T1: Standard position under 2-1/2" wide. Fig. 12: Hinged Half-Band- convenient where two piece heaters are required. Shown with Fig. 8 mounting flange and T2 screw terminals. Available with any termination or mounting arrangement.

Fig. T2: Standard position over 2-1/2"wide. Fig. 14: Half Band-eases installation in difficult situations. Shown with T1 Terminals and Fig. 10 by-pass straps. Available with any termination or mounting arrangement

Fig. T3: Standard with terminal box. Fig. 15: Probe holes and cut-outs-specify location in degrees from center of gap and size or provide drawing. Often a larger gap (standard gap is 1/4" - 1") will serve the same purpose.

Fig. B1 (shown) B2, B3: 10-32 thread requires 1/2" clearance from cylinder. Fig. 17: Splitcase-Allows heater to be opened one time for mounting. Available with any termination or mounting arrangement.

home | about ogden | products { flexible heaters & band heaters | insertion heaters | process electric heaters | strip heaters & mini-tubular heaters | radiant heaters | controls, sensors & accesories } | what's new | contact ogden

OGDEN MANUFACTURING CO.
103 Gamma Drive, Pittsburgh, PA 15238
phone 800-OMC-4921 or 412-967-3906
fax 888-OMC-9890 or 412-967-3930